600D nylon Dropleg holster w/ stud-coupling thumb break retention. This webbing is adjustable on the offside of the holster by means of stiffly pulling it. It also has a single magazine pouch on the frontal end that retains by means of velcro sealing.
It has two straps that runs from the rear side of the holster, which circles the upper leg, looping through the double bar retainer, before folding over to seal onto the velcro. These straps as such, are thus adjustable to fit a thigh from 18.5mm in diameter, through to 29mm diameter. The material holding the two bar retainers are attached to the holster, is elastic and has crossbox stitched to the short webbing strips attached to the holster. This elastic material allows for broader thighs and/or helps to spread out the elasticating stress through the webbing length.
The webbing otherwise is reinforced-stitched onto the reverse side of the holster to prevent ripping.
Furthermore, the holster has webbing w/ a clip that allows it to attach to the belt. Adjustable for height by means of a triple bar retainer as well as belt width. There is crossbox stitching to add extra integrity on the section that latches around the belt, to prevent gradual downward slippage of the holster from ripping the said webbing loose.